Network Port Adapter

Configuration module parameters Hardware connection As shown below (connect the module to the computer with TYPE-C cable and network cable)Parameter configuration of the module(1) Click “Search Device” and the device list will display the module in the subnet.(2) Select the module in the device list, modify the parameters on the left and right sides, and then click "Configure Device Parameters".(3) After the configuration is completed, the module will restart. Wait a moment, click “Search Device” to find the module and see the configuration result.Detailed operation process(1) Run NetModuleConfig.exe to set module parametersThe operation is as follows:Click Search for devices to find the device.(2) Double-click the searched device to get the parameters.(3) Modify the module parameters according to actual needsLeft setting: According to the network segment where the computer is located, the module must be set to be in the same subnet as the computer used. For example, when the subnet mask is 255.255.255.0, 192.168.1.1 and 192.168.1.2 are in the subnet. , while 192.168.1.1 and 192.168.2.1 are in different subnets. Check the IP of the computer as shown below.Set on the left:Device name: can be taken at will, such as TCP SERVERDHCP: Unchecked to enableDevice IP: 192.168.0.X (X stands for the same IP as the computer, ie X is not 10, and X can be set to 88, 66, etc., the IP set in this example is 192.168.0.88)Subnet mask: 255.255.255.0Gateway: 192.168.0.1 (in the same subnet as the device IP, the last bit is 1)Serial port negotiation configuration: unchecked to enableSet on the right:Network mode: TCP SERVERLocal port: 8000 (you can set the local port number as needed, the port number set in this example is 8000)Destination IP/Domain Name: IPDestination IP and destination port number are not grayed out by default.Serial port baud rate: 2

• Material: Plastic
• Use: Vehicles & Remote Control Toys